Motorola HT 1000 User Manual page 144

Nuisance Delete
Selectable Channel Unmute
Quik-Call II Scan
MDC Decode Scan
MDC Selective Call Scan
138
Use the UP/DOWN arrow keys to enable/disable this feature. If this
option is enabled, the user will be able to temporarily delete a busy
channel from the scan list while the radio is scanning. To delete a busy
channel, the user will have to press Side Button 1 (blue button) while
the radio is locked on the nuisance channel. The channel will be
deleted from the list until scan is shut off. The channel will reappear
in the list the next time scan is turned on.
The default is Enabled.
Use the UP/DOWN arrow keys to enable/disable this feature. If this
option is enabled, the unmuting logic of the MDC or Quik-Call II
decode will be forced to be true during scan for both priority and non-
priority channels. Detection of carrier (and PL if enabled) alone will
cause the radio to lock onto the channel. The normal decode function
of the Quik-Call II or MDC will still be active on a locked-on channel
and will generate an alert if a page is received.
Note: Be sure to consider if the use of the Priority Channel Unmute
feature would be more appropriate for a given situation. Priority
Channel unmute is more restrictive and will cause the radio to
unmute to less traffic than Selectable Channel Unmute.
The default is Disabled.
Use the UP/DOWN arrow keys to enable/disable the scanning of Quik-
Call on priority and non-priority channel if the Quik-Call II decode
option is enabled on those channels on the CHANNEL
CONFIGURATION screen (F4/F4).
The default is Enabled.
This feature is not available on JT1000 models. Use the UP/DOWN arrow
keys to enable/disable this feature. If this option is enabled, the MDC
decoder will be enabled on priority and non-priority channels during
scan. For this feature to work, MDC decode must be enabled on these
channels on the CHANNEL CONFIGURATION screen (F4/F4).
Note: This feature must be enabled if scanning of the MDC Selective
Call decode option is required.
The default is Enabled.
This feature is not available on JT1000 models. Use the UP/DOWN arrow
keys to enable/disable this feature. If this feature is enabled, the
scanning of MDC Selective Call will be enabled on priority and non-
priority channels provided MDC decode is enabled in that channel on the
CHANNEL CONFIGURATION screen (F4/F4).
Note: MDC Decode Scan MUST be enabled if you want to use this
feature.
The default is Enabled.