Read Data From Radio (Requires Rib) - Motorola HT 1000 User Manual

Read Data From
Radio (Requires RIB)
CB
Field Definition
Reading Codeplug Block
58
From the MAIN MENU, press F3 and then F2 to access this screen.
MOTOROLA Radio Service Software
HT/JT1000/VISAR Model:
MAIN:GET/SAVE/PROG:READ RADIO
Reading Codeplug Block 1 of 34
0%
|----+----+----+----+----+----+----+----+----+----+----+----|
F1 F2 F3
If the current work space has been changed but not saved, you will be
prompted to press F2 to read the radio. Otherwise, the radio will be
read directly. If communication with the radio fails, a pop-up window
will be displayed with an error message. (Error codes are listed in
Appendix A.)
Note: You may read the codeplug from the radio or from the
archive disk. Refer to the following page for instructions on
reading codeplug data from an archive disk.
If no errors occur, the center of the screen will display the progress of
the codeplug reading activity. The read process will take
approximately one minute. (This duration may vary depending on the
type of computer being used and the size of the codeplug being read.)
After the codeplug is read, you will automatically be returned to the
GET/SAVE/PROGRAM MENU. The model number and serial number
will be updated upon returning to the GET/SAVE/CLONE screen.
This is the number of blocks that have been read. The status bar shows
the relative value of the number of blocks read so far compared to the
total number of blocks to be read.
READ RADIO CODEPLUG
-------------------
F4 F5 F6 F7
100%
F8 F9 F10