Motorola HT 1000 User Manual page 113

Channel Revert
Priority Revert Channel
This field will be visible only if the Emergency field on this screen is set to
Enabled. Use the UP/DOWN arrow keys to enable/disable this option.
If this feature is enabled, emergency channel revert mode operation
will be enabled in the radio.
This mode of operation will cause the radio to change from the
selected channel to the specified Revert channel when the Emergency
button is pressed. After the Emergency message is transmitted and the
Acknowledgment is received, the radio will return to the selected
channel.
Note: The MDC/STAR/ATIS Decode field on the CHANNEL
CONFIGURATION screen (F4/F4) must be set to Enabled in order for
the radio to be able to decode the Emergency Ack that is generated
from the MDC fixed equipment. This feature needs to be enabled
only on the Emergency Revert channel and only when
Emergency Revert is in use.
The default is Disabled.
This field will be visible only if the Emergency field on this screen is set to
Enabled. Use the UP/DOWN arrow keys to make your selection or enter
the desired number directly for the channel to be used for emergency
transmission when Channel Revert mode is enabled.
The valid range of channels is 1 through the maximum number of
channels allowed in the radio. Only channels marked as
"Programmed" in the CHANNEL CONFIGURATION screen (F4/F4)
will be displayed as possible selections.
The default is 1.
Note: If an Advantage™ Board is installed in the radio and the
Emergency button (orange top button) is functionally used by the
Advantage Board, that button must be set to "Blank" to prevent dual
usage.
107