Motorola HT 1000 User Manual page 110

PTT Sidetone
Emergency Sidetone
Remote Monitor
Radio Check
MDC Auto Reset
104
Use the UP/DOWN arrow keys to enable/disable this option. If this
feature is enabled, a sidetone will be generated during encoding of a
Stat-Alert PTT-ID and STAR PTT-ID. Sidetones are not compatible with
PTT-ID on de-key.
The default is Enabled.
Use the UP/DOWN arrow keys to enable/disable this option. If this
feature is enabled, a sidetone will be generated during encoding of a
Stat-Alert Emergency ID.
The default is Disabled.
This feature is limited to HT 1000 "B" models and VISAR models with
firmware version 2.06 or later. If this field is enabled on a radio having an
earlier version firmware or on a JT1000 radio, it will have no effect.
Use the UP/DOWN arrow keys to enable or disable this field. If this
field is set to Enabled, the decoding for the MDC Remote Monitor
command will be activated. The Remote Monitor command will cause
the radio to key up and transmit ambient audio for a period of time
that is controlled by the command itself. The time period will be
determined by multiplying a value of 20 seconds with the number in
the MDC Remote Monitor command's multiplier field.
The default is Disabled.
Use the UP/DOWN arrow keys to enable/disable this option. If this
option is enabled, the dispatcher can send a message to a radio which
stimulates a specific response, verifying that the radio is turned on and
within range of the system.
The default is Enabled.
Use the UP/DOWN arrow keys to enable/disable this timer. This
option enables you to use the Auto-Reset timer for MDC Selective Call
signalling.
The Auto-Reset timer allows a two-way conversation to follow a
Selective Call. When the conversation ends, the radio will
automatically be returned to Page mode. The auto reset timer specified
on the RADIO SYSTEM CONFIGURATION screen (F4/F3/F2) will be
initiated after the Selective Call is received and the Alert Tone
sequence is sounded. The radio will return to Page mode (signalling
squelch) if:
• There is a period of inactivity (no carrier) on the channel for the
duration of the Auto Reset timer; and
• No PTT presses occur for the duration of the timer.
If carrier is detected, or PTT pressed, the timer will be reset and
restarted. The timer is common to both Quik-Call and MDC signalling
systems. Its duration is set on the RADIO SYSTEM CONFIGURATION
screen (F4/F3/F2) screen.
The default is Enabled.