Motorola HT 1000 User Manual page 150

Stat-Alert/ATIS Sel-Call
PTT ID
MDC/STAR/ATIS Decode
144
This field will be visible only for HT 1000 and VISAR radios. This field will
NOT be visible for JT1000 radios. Use the UP/DOWN arrow keys to
enable/disable this feature. Enabling this field allows the dispatcher to
voice-page the radio individually or as part of a group. When a
Selective Call is received, two beeps will be sounded and the LED will
flash green. The radio will then unmute and a voice message will
follow. The green LED will continue to flash for the length of the
message. When the voice message ends, the radio will return to
normal operation.
Note: MDC/STAR/ATIS Signalling Decode must be enabled for Sel
Calls to be received. Signalling decode of any type is incompatible
with Quik-Call II decoding on the same channel. It is also
incompatible with Battery Saver. Battery Saver will be disabled when
this feature is enabled.
The default is Disabled.
Use the UP/DOWN arrow keys to enable/disable this feature. This field
must be enabled for PTT-ID to be allowed on a particular channel. PTT-ID
is an identification code transmission that is tied to the PTT switch.
The code is automatically sent every time the PTT button is pressed.
When PTT-ID precedes voice transmission, a sidetone is generated (if
enabled) until ID transmission is completed, to prevent talking during
transmission of the ID code.
PTT-ID is a generic term which refers to a function which is possible in
several signalling formats. PTT-ID variations enabled by this field are
MDC, STAR, DTMF ANI and ATIS.
Note: This feature is incompatible with Talkaround. Only one PTT-
ID function can be used per radio at any time. In the case of a JT1000
radio, only DTMF ANI applies.
The default is Disabled.
This field will be visible only for HT 1000 and VISAR radios. This field will
not be visible for JT1000 radios. This feature enables signalling decode
for MDC signalling on this channel. It is required to receive Stat-Alert
Sel Calls, Radio Checks, as well as Emergency Message
Acknowledgments and for Data Operated Squelch to function.
Note: It is incompatible with Quik-Call II decoding on the same
channel. It is also incompatible with Battery Saver. Battery Saver will
be disabled when this field is set to Enabled.
The default is Disabled.