Motorola HT 1000 User Manual page 98

Power-Up Alert
Illegal Channel Alert
Timeout Timer Alert
Timeout Timer Pre-Alert
PL Defeat Alert
Scan Programming Alert
Priority Channel Lock Alert
PTT Tx Inhibit Alert
92
Use the UP/DOWN arrow keys to enable/disable the Power-Up Alert
tone that the radio emits when it powers up. The frequency of the
Power-Up Alert tone depends on the outcome of the radio's self-test
routine. If the radio's circuitry passes the self-test, the Power-Up Alert
tone will be sounded at 900 Hz (high tone) for 75 ms. If the self-test
fails in a non-fatal fashion, the Power-Up Alert tone will be sounded at
300 Hz (low tone) for 75 ms, and the radio will continue to operate.
The default is Enabled.
Use the UP/DOWN arrow keys to enable/disable this feature. When
this feature is enabled and a non-programmed channel is selected, an
alert tone will be emitted to warn the user that it is invalid.
The default is Enabled.
Use the UP/DOWN arrow keys to enable/disable the transmit Timeout
Timer Alert feature. If this feature is enabled, this alert tone will be
sounded from the time that the timeout timer (TOT) expires until the
time that the PTT button is released.
The default is Enabled.
Use the UP/DOWN arrow keys to enable/disable the Timeout Timer
Pre-alert feature. If this feature is enabled, a pre-alert tone will be heard
four seconds before the timer times out.
The default is Disabled.
Use the UP/DOWN arrow keys to enable/disable this feature. If this
feature is enabled, the radio will generate an alert before it enters the
PL Defeat mode. The radio will enter Permanent PL Defeat mode when
the Monitor button is held down for more than five seconds.
The default is Enabled.
Use the UP/DOWN arrow keys to enable/disable this feature. If this
feature is enabled, an alert will be generated when the radio user enters
or exits Scan Programming mode.
The default is Enabled.
Use the UP/DOWN arrow keys to enable/disable this feature. If this
feature is enabled, an alert tone will be generated while in Priority Scan
and unmuting on the priority channel.
The default is Enabled.
Use the UP/DOWN arrow keys to enable/disable this feature. If this
feature is enabled, an alert tone will be generated if the radio user
presses the PTT button when the radio's transmission is inhibited (ex.
Rx only channel, busy channel, etc.).