Motorola HT 1000 User Manual page 95

Monitor Long Press Period (sec)
Scan Allows the operator to select a channel's status in the
Programming scan list by scrolling through the three states (Not in List,
Status Scroll Non-Priority, Priority) as this button is pressed. The
status of the channel is indicated by the bi-color LED.
LED OFF indicates "Not in Scan List", LED Green
indicates "Non-Priority Status" and LED Red indicates
"Priority Status".
Monitor/Scan Combines the Monitor function with Scan Programming
Programming Status Scroll while in Scan Programming mode.
Status Scroll
Select Allows the radio user to temporarily remove a channel
from the scan list in the Nuisance Delete function, and
performs the Scan Programming Status Scroll function in
Scan Programming mode.
Scan/Scan A short press will toggle the Channel Scan mode on and
Programming off. A long press will place the radio in the Scan
On/Off Programming mode, where the scan list can be modified
by the radio operator.
Note: In Scan Programming mode, the radio will not
unmute to channel traffic. A tone will sound to remind
the operator if the radio has been left in the Scan
Programming mode with no key activity for more than
20 seconds. To complete the Operator Selectable scan
functionality, the other side button must be assigned to the
Scan Programming Status Scroll function. Scan-related
button setups can be found on the following page.
MSPL Select Allows the user entry/exit to the Multiple Selectable PL/
DPL entry mode. Available with JT1000 models only.
Note: This function allows the user to substitute the
squelch coding on one channel onto another channel.
Available only on Sidebutton 2 of JT1000 models.
Single Tone #1 Initiates transmission of the selected Single Tone.
and #2 Encode
Scan On/Off Allows scan to be toggled on and off. No scan
programming is allowed with this setup.
Light Allows toggling of the keypad backlighting on and off on
keypad-equipped radios only.
Enter a value directly or use the UP/DOWN arrow keys to select the
length of time that the Monitor Button must be held down to engage
Permanent Monitor mode. The valid range of values is 1 to 16 seconds.
The default is 5 seconds.
89