Radio Service Software Information; Configuring The Rib And Radio - Motorola GTX 2000 Service Manual

GTX/GTX LTR /LTS 2000 Portable Radios Service Manual

Radio Service Software Information

To run the Radio Service Software, you will need the following equipment:
Required Equipment:
1. IBM XT, AT, Convertible, or System/2 Model 30/50
Floppy Disk and one Hard Disk.
TM
2. PC DOS or MS-DOS
3. Radio Interface Box (RIB) RLN4008.
4. RIB to IBM AT cable 30-80369B72.
5. IBM AT cable to IBM XT computer adapter (optional) RLN4438.
6. Programming/Test cable.
7. RIB power supply 0180357A57 (120 Vac) or 0180358A56 (220 Vac).
0180357A57 (120 Vac) or
0180358A56 (220 Vac)
RIB Power Supply.
Plugs into 120 or 220 Vac outlet.
RLN4008
Power Supply (7.5 Vdc)
Note: Battery can be used on
programming cable making
power supply optional.
Configuring the RIB and Radio
1. Connect the RIB to the computer (Figure 2).
2. Plug the large 25-pin end of the HKN9857 programming cable into the RIB. The other end of this cable has
a Òbattery eliminator.Ó
3. Slide the battery eliminator in place of the radioÕs battery.
4. Plug power supply 0180357A57 (120 Vac) or 0180358A56 (220 Vac) into a wall outlet, and connect the other
end to the RIB.
5. Connect the radio to a power supply and turn the volume control clockwise to turn it on.
June 1999
TM
3.0 or later.
30-80369B72 or
30-80369B71
RIB to Computer Cable.
Plugs into RIB and computer.
15 PIN
(
RIB)
25 PIN
HKN9857
Programming / Test cable.
Connects between the RIB and radio.
Figure 2. Equipment Setup
TM
with 512K RAM, Dual Floppy Disk Drives or one
68P02945C75-A
Radio Service Software Information
RSS
Computer
RVN4150D for GTX/GTX LTR or
RVN4156F for LTS 2000
Software
GTX/GTX LTR
LTS 2000 Radio
Foreword
Manual
xv