Motorola HT 1000 User Manual page 107

Sleep Period (ms)
Auto Reset
QC Select Call LED
Enter a value directly or use the UP/DOWN arrow keys to specify the
radio's "sleep period" when it is in battery-saver mode. For a channel
with the Quik-Call II Decode option enabled, the sleep period is related to the
first tone and must be programmed so that pages are not lost. The default
sleep period of 60 ms is calculated to be safe for a system with a tone
duration of 500 ms or greater. Valid values for Sleep Period range from
five to 1050 ms in five-ms increments.
The default is 60 ms.
Use the UP/DOWN arrow keys to enable/disable this timer. This
option allows you to use the Auto-Reset timer for Quik-Call II
signalling.
The Auto-Reset timer allows a two-way conversation to follow a
Selective Call. When the conversation ends, the radio will
automatically be returned to Page mode. The auto reset timer specified
on the RADIO SYSTEM CONFIGURATION screen (F4/F3/F2) is initiated
after the Selective Call is received and the Alert Tone sequence is
sounded. The radio will return to Page mode (signalling squelch) if:
• There is a period of inactivity (no carrier) on the channel for the
duration of the Auto Reset timer; and
• No PTT presses occur for the duration of the timer.
If carrier is detected or PTT is pressed, the timer will be reset and
restarted.
Note: The timer is common to both Quik-Call and MDC signalling
systems.
The default is Enabled.
Use the UP/DOWN arrow keys to enable/disable this option. If this
feature is enabled, the Receive Select Call LED will flash when a Select
Call (either a Quik-Call II or MDC Select Call) is received.
The default is Enabled.
101