Motorola HT 1000 User Manual page 183

Field
DOS Coast Time
Auto Timed Mute
Duration
Auto Reset Timer
Stat-Alert/ATIS Sel Cal
PTT-ID
MDC/STAR/ATIS
Decode
Talkaround
Repeater Access
Signalling Muting
Dispatch
Accept Alert
Silent Pretime
Code 1 - Code 8
MDC Decode Scan
MDC Sel Call Scan
Remote Monitor
Sticky Revert
Sticky Revert Alert
Open Mic Duration
Mandown Pre-Alert
Delay
Mandown Post-Alert
Delay
MDC Signalling
Function
Time that Data Detect can be lost before
unmute
Length of auto-mute on Carrier Detect
Radio-wide setup of Auto Reset Timer length
Enables Select Call for the current channel
Enables PTT-ID Encode for the current channel
Enables Signalling Decode for the current
channel
Incompatible with PTT-ID and RAT if enabled
Enables Repeater Access for the current channel
Sets whether the radio responds to only
Selective Calls or to normal condition as well
Enables chirp when RAT Side Button is pressed
Sets Pretime between Keyup and first bit of RAT
data
Sets Repeater ID to be accessed
Enables MDC Decoder in scan on MDC-
enabled channels
Enables scanning for MDC Sel-Cal on MDC-
enabled channels
Enables radio to respond to the MDC Remote
Monitor command
Enables radio to operate in the Sticky Revert
Mode when MDC Emergency Revert is used
Enables radio to generate Alert Tone whenever
Operator keys up on the Sticky Revert Channel,
which may be different from the selected
channel
Enables radio to automatically key up with
Open Microphone for a programmable amount
of time after MDC Emergency Alarm Sequence
is completed
Length of time from the point that the
mandown switch is pressed until the time that
an alert is generated
Length of time between the mandown alert
tone and transmission of the Emergency Alarm
sequence
Location
CHANGE:RADIO:SIG:MDC:OPT
CHANGE:RADIO:SIG:MDC:OPT
MDC OPTIONS DECODE CHANNEL
CHANGE:RADIO:SYS CONFIG
CHANGE:CHANNEL
CHANGE:CHANNEL
CHANGE:CHANNEL
CHANGE:CHANNEL
CHANGE:CHANNEL
CHANGE:CHANNEL:OPT
CHANGE:RADIO:SIG:MDC:RAT ID
CHANGE:RADIO:SIG:MDC:RAT ID
CHANGE:RADIO:SIG:MDC:RAT ID
CHANGE:RADIO:SCAN:CONFIG
CHANGE:RADIO:SCAN:CONFIG
CHANGE:RADIO:SIG:MDC CONFIG
CHANGE:RADIO:SIG:MDC CONFIG
CHANGE:RADIO:SIG:MDC:CONFIG
CHANGE:RADIO:SIG:MDC:OPT
CHANGE:RADIO:SIG:MDC:OPT
CHANGE:RADIO:SIG:MDC:OPT
177