Equipment Checklist - Motorola HT 1000 User Manual

Equipment
Checklist
IBM Personal Computer
Radio Interface Box (RIB)
Wall-Mounted Power Supply
(for RIB)
Computer Interface Cable
Program/Test Cable
HT/JT1000/VISAR RSS
Portable Products Test Set
Battery Eliminator
5 Amp Power Supply (for radio)
Cloning Cable
Listed below are all the equipment required to program a HT 1000,
JT1000, or VISAR radio using the RSS.
It is strongly recommended that this RSS be run on an IBM PC, IBM
PC compatible or PS/2 computer with the following minimum
configuration:
• 80286 CPU or higher;
• An asynchronous communications adapter;
• MS-DOS 5.0 or higher (with DOS running in high memory);
• 4 Megabytes of RAM or greater; and
• At least 512K of free, conventional memory. (The DOS CHKDSK
command can be used to determine the amount of free RAM
available on your computer.)
Part Number RLN-4008B (includes internal 9-volt Battery). Allows the
computer to communicate with the radio via its asynchronous
communications adapter.
Part Number 01-80357A57 – 120V AC/DC Converter
Part Number 01-80358A56 – 220V AC/DC Converter
Part Number 60-82728J01 – 9V Battery
Part Number 30-80369B71 – 25-pin D connector (computer end),
15-pin D connector (RIB end)
Part Number 30-80369B72 – 9-pin D connector (computer end),
15-pin D connector (RIB end)
This hardware connects the computer's asynchronous
communications adapter to the RIB.
Part Number RKN4035D for HT/JT1000 radios and Part Number
RKN4042A for VISAR radios. Provides electrical connections to the
RIB, Portable Products Test Set, and the radio.
Part Number RVN-4098G (One 3-1/2 inch double-density floppy disk
is included.)
Part Number RTX-4005B. Provides the capability to test many
transmitter and receiver functions. Transmitter modulation and
keying can be tested without disassembling the radio. The Test Set is
used in conjunction with the programming/test cable.
Part Number RLN1014A for HT/JT1000 and RLN4327A for VISAR
radios. Replaces the battery pack during servicing.
Supplies power to the battery eliminator.
Part Number RLN4036A for HT/JT1000 radios and Part Number
RKN4043A for VISAR radios. Used to connect two radios so that the
codeplug (personality) of the source radio can be programmed into the
target radio.
3