Table of Contents
Advertisement
Chapter 6
Deploying Firepower Managed Devices
Complex Network Deployments
Integrating Multiple Management Interfaces within a Complex Network
You can configure multiple management interfaces in any deployment to isolate traffic from devices that
monitor different networks and are managed by the same Firepower Management Center. Multiple
management interfaces allow you to add a management interface with a unique IP address (IPv4 or IPv6)
to your Firepower Management Center, and create a route from that management interface to a network
that contains the device you want to manage. When you register your device to the new management
interface, traffic on that device is isolated from traffic on devices registered to the default management
interface on the Firepower Management Center.
You must register a device to the static IP address of any management interface other than the default
Tip
(
) management interface. DHCP is supported only on the default management interface.
eth0
Firepower 8000 Series Hardware Installation Guide
6-22
Advertisement
Table of Contents
