Advertisement
Table of Contents
System Status Mode
The LCD panel displays the following:
Edit the default gateway the same way you edited the IP address, and press the check mark key to accept
Step 9
the changes.
The LCD panel displays the following:
Press the check mark key to save your changes.
Step 10
Allowing Network Reconfiguration Using the LCD Panel
Because it presents a security risk, the ability to change network configuration using the LCD panel is
disabled by default. You can enable it during the initial setup process (see the see the Firepower 8000
Series Getting Started Guide), or using the device's web interface as described in the following
procedure.
To allow network reconfiguration using a device's LCD panel:
After you complete the initial setup of the device, log into the device's web interface using an account
Step 1
with Administrator privileges.
Select
Step 2
The Information page appears.
Step 3
Click
The Network Settings page appears.
Step 4
Under LCD Panel, select the
warning appears, confirm that you want to enable this option.
For information on the other options on this page, see the Firepower Management Center Configuration
Tip
Guide.
Click
Step 5
The network settings are changed.
System Status Mode
The LCD panel's System Status mode displays monitored system information, such as link state
propagation, bypass status, and system resources. You can also change the LCD panel's brightness and
contrast in System Status mode.
Firepower 8000 Series Hardware Installation Guide
4-6
Default Gateway
- +
000.000.000.000
X
Save?
X
Admin
Access:
System > Local > Configuration
Network
.
Allow reconfiguration of network configuration
.
Save
Chapter 4
.
Using the LCD Panel on a Firepower Device
check box. When the security
Advertisement
Table of Contents
