Where To Find Safety And Warning Information - Cisco AMP8050 Hardware Installation

About This Guide
Faceplates and Cover Panels Warning
Warning Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they restrict electromagnetic interference
(EMI) that might disrupt other equipment; and they direct the flow of cooling air through the chassis.
Do not operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statements 1029 and 142
Product Disposal Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
Compliance with Local and National Electrical Codes Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Grounded Equipment Warning
This equipment is intended to be grounded. Ensure that the host is connected to earth ground during
Warning
normal use. Statement 39
Safety Cover Requirement
The safety cover is an integral part of the product. Do not operate the unit without the safety cover
Warning
installed. Operating the unit without the cover in place will invalidate the safety approvals and pose
a risk of fire and electrical hazards. Statement 117

Where to Find Safety and Warning Information

For safety and warning information, see the Regulatory Compliance and Safety Information document
at the following URL:
http://www.cisco.com/c/en/us/td/docs/security/firesight/hw-docs/regulatory/compliance/firesight-firep
ower-rcsi.html
This RCSI document describes the international agency compliance and safety information for the
Cisco Firepower series.
Where to Find Safety and Warning Information
Firepower 8000 Series Hardware Installation Guide
ix