Remove The Module Or Slot Cover - Cisco AMP8050 Hardware Installation

Appendix B Inserting and Removing Firepower 8000 Series Network Modules
Unplug all power cords from the appliance.
Step 4
.
Related Topics
•
•

Remove the Module or Slot Cover

Use proper electrostatic discharge (ESD) practices such as wearing wrist straps and using an ESD work
surface when handling the modules. Store unused modules in an ESD bag or box to prevent damage.
Procedure
Remove and reserve the T8 Torx screw from the lever of the module using the included screwdriver.
Step 1
Pull the lever away from the module to release the latch.
Step 2
Slide the module out of the slot.
Step 3
"Placing a High-Availability Peer into Maintenance Mode" chapter in the Firepower Management
Center Configuration Guide.
"Replacing a Device in a Stack in a High-Availability Pair" chapter in the Firepower Management
Center Configuration Guide.
Remove the Module or Slot Cover
Firepower 8000 Series Hardware Installation Guide
B-5