Firepower 8000 Series Devices
Table 2-6
LED
Left (activity)
Right (link)
The power supply modules are located on the rear of the appliance. The following table describes the
LEDs associated with the management interface.
Table 2-7
LED
Off
Amber
Blinking amber
Blinking green
Green
The following table lists the signals on a typical DB-9 serial connector and the corresponding pins on
the device's RJ45 serial connectors. You can use this table to construct an adapter for serial connections.
Table 2-8
DB-9 Pin
1
2
3
4
5
6
7
8
9
Firepower 8000 Series Hardware Installation Guide
2-8
Firepower 8000 Series Management Interface LEDs
Description
Indicates activity on the port:
•
A blinking light indicates activity.
•
No light indicates there is no activity.
Indicates whether the link is up:
A light indicates the link is up.
•
No light indicates there is no link.
•
Firepower 8000 Series Power Supply LEDs
Description
The power supply is not plugged in.
No power supplied to this module.
or
A power supply critical event such as module failure, a blown fuse, or a fan
failure; the power supply shuts down.
A power supply warning event, such as high temperature or a slow fan; the
power supply continues to operate.
AC input is present; volts on standby, the power supply is switched off.
The power supply is plugged in and on.
Firepower 8000 Series RJ45 to DB-9 Adapter Pin-Out
Signal
Description
DCD/DSR
Data carrier detect/data set ready
RD
Receive data
TD
Transmit data
DTR
Data terminal ready
GND
Ground
No connection
RTS
Request to send
CTS
Clear to send
No connection
Chapter 2
Hardware Specifications
RJ45 Pin
7
6
3
2
4 & 5
1
8