Advertisement
Table of Contents
Appendix B
Inserting and Removing Firepower 8000 Series Network Modules
Restart the Appliance
Before You Begin
•
•
Procedure
Choose System > Configuration.
Step 1
Choose Process.
Step 2
Click Run Command next to Restart Appliance Console.
Step 3
Verify the NetMod from the Firepower Management Center
Procedure
Step 1
Choose Devices > Device Management.
Next to the device where you want to view the interfaces, click the edit icon (
Step 2
Verify the interfaces on the Interfaces tab.
Step 3
If your appliance is part of a device stack or high-availability pair, bring the device out of maintenance
Step 4
mode from the Firepower Management Center:
•
•
What to Do Next
•
•
Apply Changes to the Appliance
After you make changes to the configuration of a device, a device cluster, or a device stack, you must
apply the changes before they take effect throughout the system. Note that the device must have
unapplied changes or this option remains disabled.
Note that if you edit interfaces and reapply a device policy, Snort restarts for all interface instances on
the device, not just those that you edited.
Plug in all power cords to the appliance.
Wait until the appliance is fully powered up. This could take several minutes.
Choose Devices > Device Management.
Next to the stack member or peer, click the toggle maintenance mode icon (
out of maintenance mode.
Configure the new interfaces. See the "Interface Configuration Settings" chapter in the Firepower
Management Center Configuration Guide.
Apply the configuration changes.
Firepower 8000 Series Hardware Installation Guide
Restart the Appliance
).
) to bring the device
B-9
Advertisement
Table of Contents
