Installing A Malware Storage Pack On A Version 6.0.1 Device - Cisco AMP8050 Hardware Installation

Appendix C Installing a Malware Storage Pack
Turn on the system.
Step 5
Refer to <Blue>Post Installation on page 11 for information on restarting a device after a malware
storage pack has been installed.

Installing a Malware Storage Pack on a Version 6.0.1 Device

Use the following procedure to install a malware storage pack in a device already configured and running
Firepower System version 5.3 or greater.
To install malware storage pack in a device running version 5.3 or greater:
Step 1 Shut down the system.
Step 2 Power off the device.
Step 3 Install the malware storage pack:
•
•
Turn on the system.
Step 4
•
Instructions for the 81xx Family Devices
The following section describes how to install a malware storage pack in the 81xx Family of devices,
which includes the Firepower 8120, 8130, and 8140 devices. Note that the malware storage pack is not
supported on the AMP8150 device.
81xx Family Chassis Front View
The SSD trays are located on the front of the 81xx Family chassis.
Figure C-1
For 81xx Family devices, refer to <Blue>Instructions for the 81xx Family Devices on page 5.
For 82xx Family and 83xx Family devices, refer to <Blue>Instructions for the 82xx Family and 83xx
Family Devices on page 8.
Refer to <Blue>Post Installation on page 11 for information on restarting a device after a second
SSD has been installed.
81xx Family (Chassis: CHAS-1U-AC/DC) Front View
Firepower 8000 Series Hardware Installation Guide
Installation
C-5