Table of Contents
Advertisement
Installation
Figure C-2
The following steps describe how to install a malware storage pack in the 81xx Family of devices. Install
the malware storage pack in the SSD bay labeled Malware Storage Pack. Remove the empty SSD tray and
replace it with the appropriate malware storage pack.
Use proper electrostatic discharge (ESD) practices such as wrist straps and an ESD work surface.
Note
Step 1
Ensure the device is powered off before you begin to install or remove a malware storage pack.
Step 2
Use the T8 Torx driver to remove the Torx screw on the right side of the second SSD tray. Retain the
screw.
Unscrew and pull on the thumbscrew to remove the empty SSD tray from the device.
Step 3
Note
Retain the empty SSD tray. If you need to remove the malware storage pack at any time, reinstall the
empty tray in the device.
Step 4
Remove the malware storage pack from its packaging.
Firepower 8000 Series Hardware Installation Guide
C-6
SSD Detail
Appendix C
Installing a Malware Storage Pack
Advertisement
Table of Contents
