Cisco AMP8050 Hardware Installation page 44

Identifying the Sensing Interfaces
Figure 3-8
You can use these connections to passively monitor up to four separate network segments. You also can
use paired interfaces in inline configuration on up to two network segments.
Figure 3-9
The quad-port 1000BASE-SX fiber non-bypass configuration uses LC-type (Local Connector) optical
transceivers.
You can use these connections to passively monitor up to four separate network segments. You also can
use paired interfaces in inline configuration on up to two network segments.
For best performance, use the interface sets consecutively. If you skip interfaces, you may experience
Tip
degraded performance.
Figure 3-10
The quad-port 10GBASE fiber non-bypass configuration uses LC-type (Local Connector) optical
transceivers with either MMSR or SMLR interfaces.
The quad-port 10G BASE non-bypass NetMod contains non-removable small form-factor pluggable
Caution
(SFP) transceivers. Any attempt to remove the SFPs can damage the module.
You can use these connections to passively monitor up to four separate network segments. You also can
use paired interfaces in inline configuration on up to two network segments.
Firepower 8000 Series Hardware Installation Guide
3-8
Quad-Port 1000BASE-T Copper Non-Bypass NetMod
Quad-Port 1000BASE-SX Fiber Non-Bypass NetMod
Quad-Port 10GBASE (MMSR or SMLR) Fiber Non-Bypass NetMod
Chapter 3 Installing a Firepower 8000 Series Device