Step 2-Position And Secure Unit; Step 3-Attach Omni-Directional Antennas; Figure 26: Inserting Shoulder Screws Into Mounting Bracket Holes - Belair 100SN Installation Manual

BelAir100SN Installation Guide
Step 2—Position and
Secure Unit
Step 3—Attach
Omni-directional
Antennas
May 18, 2010
1 Lift the unit to the height of the mounting bracket.
2 Refer to Figure 26. Slowly lower the unit onto the mounting bracket such
that the four shoulder bolts slide into the bolt holes then into the slots on
the mounting bracket. The bracket should now be holding the weight of the
unit.
Note: The BelAir100SN must be installed with the connectors closest to the
ground.

Figure 26: Inserting Shoulder Screws into Mounting Bracket Holes

3 Slide the pedestal security bracket down until it sits against shoulder screw
bosses on the BelAir100SN casting. The hole in the brackets align to use a
paddle lock if desired. Tighten the 7/16-inch nut to secure the security
bracket in place.
1 Locate a female-to-female bulkhead adaptor from the Pedestal Antenna Kit.
See Figure 27 on page
Confidential
Document Number BDTK11001-A01 Preliminary
Pedestal Installation of the BelAir100SN
Insert BelAir100SN
shoulder screws
into mounting
bracket key holes
50. Remove the retaining nut and lock washer.
Page 49 of 75