Table of Contents
Advertisement
BelAir100SN Installation Guide
Step 1—Prepare Unit
Figure 10: BelAir100SN Connector Fields
GRS
Connector
Step 2—Attach
Antennas As Required
May 18, 2010
Strand mounting the BelAir100SN with Omni-directional Antennas
1 Unpack the BelAir100SN unit. Carefully remove the unit from the box.
Remove the unit from its shipping bag.
2 Refer to
Figure
If you are connecting this unit to an electrical Ethernet cable, remove the
protective cover now. Otherwise, ensure that the protective cover is
secure.
Right Side View
Omni-directional antennas can be mounted in any of the four top corners of
the BelAir100SN unit. However, BelAir Networks recommends that you install
both your antennas on the same vertical plane closest to the road. See
on page
16.
Your unit is shipped with two omni-directional antennas. Each is pre-bolted to
its mounting bracket, ready to be attached to the BelAi100SN unit.
1 Using a 5/16 inch (8 mm) wrench, attach the first antenna bracket to the
BelAir100SN. See
Document Number BDTK11001-A01 Preliminary
10. Locate the protective cover for the Ethernet connector.
Strand Cable
Clamp
Strand Mount
Bracket
Antenna
Connectors
Ethernet
Connector
Figure 11 on page
31. Use the provided mounting screws
Confidential
Left Side View
Figure 6
Page 30 of 75
Advertisement
Chapters
Table of Contents
Troubleshooting
