Step 3-Connect Antennas; Figure 16: Attaching Directional Antenna To Belair100Sn - Belair 100SN Installation Manual

BelAir100SN Installation Guide
Step 3—Connect
Antennas
May 18, 2010
Strand mounting the BelAir100SN with Directional Antennas
location. If this is an issue, try mounting the backhaul antenna in
another corner of the unit.
1 Attach the directional antenna on the appropriate corner of the
BelAir100SN unit by loosely inserting screws in the pivot hole and azimuth
hole. See Figure 16 on page
washers.

Figure 16: Attaching Directional Antenna to BelAir100SN

2 Repeat the previous step for the other antenna, as required.
The antenna cables may have either hex-heads for wrench tightening or knurled
ends for finger tightening. If the antenna cables have knurled ends, use your
fingers to firmly tighten the connection. If you have hex-heads, do not tighten
these connectors beyond 30 inch-pounds of torque. If a torque wrench is
unavailable, BelAir recommends that these connectors be hand tightened plus
one quarter turn.
Use thread-locker to secure the connection and ensure a waterproof seal
between the antenna and its RF cable.
As a further measure to ensure a waterproof seal and to reduce any possible
mechanical loosening of the connector, installers should wrap the connectors
with self-amalgamating tape. Installers should take steps to ensure that the
antenna connections remain mechanically tight and waterproof at all times.
Confidential
Document Number BDTK11001-A01 Preliminary
38. Use the provided mounting screws and
Azimuth hole
Pivot hole
2.4 GHz Antenna
Page 38 of 75