Verifying The Package Contents - Belair 100SN Installation Manual

BelAir100SN Installation Guide
Verifying the Package
Contents
May 18, 2010
Table 8: Installation Checklist (Continued)
Done? Step Description
2 Ensure that you have the
your unit and that they contain the minimum required
information described in
The Node Configuration Sheets are available in the
Guide
It is also useful to record some physical parameters of the
install, including location (building name, address, reference
number) and circuit number (if applicable). This information
may be useful while troubleshooting.
3 Ensure that the site has been properly prepared. Refer to
"Infrastructure Requirements for the BelAir100SN" on
page
4 Verify the contents of your shipping container. Be sure to
note any external carton damage with your shipper to
facilitate any future warranty claims. See
Package Contents" on page
The BelAir100SN is shipped complete, in one box with the following
components:
• BelAir100SN unit complete with stand mount hardware
• two omni-directional antenna assemblies each consisting of:
—antenna bracket, omni-directional antenna, 24-inch (approx. 60 cm) RF
cable assembly
—two 5/16-inch (8 mm) hex-head mounting screws with washers
Note 1: If you ordered your BelAir100SN without antennas, it is shipped
without the omni-directional antenna assemblies.
Note 2: If you are installing this unit outdoors and connecting it to an electrical
Ethernet cable, you need an additional Ethernet gland to make the
connection water proof. The Ethernet gland can be ordered separately
from BelAir Networks.
Confidential
Document Number BDTK11001-A01 Preliminary
Before You Install the BelAir100SN
Node Configuration Sheets
Table 7 on page
.
6.
22.
"Verifying the
27.
Page 27 of 75
for
User