Mounting Options; Strand Mounting; Pedestal Installations - Belair 100SN Installation Manual

BelAir100SN Installation Guide

Mounting Options

Strand Mounting

Pedestal
Installations
May 18, 2010
This chapter describes the various ways that a BelAir100SN unit can be
mounted, including:
• "Strand Mounting" on page 19
• "Pedestal Installations" on page 19
Any identified specific third party parts are recommendations or examples only.
Substitution of equivalent parts is permitted. (If you are unsure of the
equivalency of a certain component, contact BelAir Networks.)
Liability
Regardless of the mounting option you choose, the recommendations made in
this document are for reference only. The customer is responsible for ensuring
that installations are carried out in compliance with national, regional and local
building codes, and any applicable electrical safety authority standards.
Always follow the manufacturer's recommendations when using third party
installation hardware.
Always maintain safe working practices and use appropriate personal protective
equipment.
The BelAir100SN is designed to be clamped on stranded messenger wire
between 1/4 and 3/8 inch (approx. 6 and 10 mm) diameter.
A BelAir100SN unit must be mounted at least 18 inches (approx. 45.7 cm) from
the nearest pole to avoid shadowing effects.
For details, see:
• "Strand mounting the BelAir100SN with Omni-directional Antennas" on
page 29.
• "Strand mounting the BelAir100SN with Directional Antennas" on page 36
With the BelAir Pedestal Mounting Kit (BNCKG0114) and the BelAir Pedestal
Antenna Kit, you can mount the BelAir100SN in a Channell Signature Pedestal
Housing (SPH-1212). The installation works with the B1 bracket and B2 bracket
(preferred). The SPH1212 pedestal measures 12 inches x 12 inches x 32 inches.
Figure 9 on page 20 shows SPH1212 pedestal with the installed BelAir100SN.
Confidential
Document Number BDTK11001-A01 Preliminary

Mounting Options

Page 19 of 75