Strand Mounting The Belair100Sn With Directional Antennas; Step 1-Prepare Unit - Belair 100SN Installation Manual

BelAir100SN Installation Guide

Strand mounting the BelAir100SN with Directional Antennas

Step 1—Prepare Unit
May 18, 2010

Strand mounting the BelAir100SN with Directional Antennas

Installation of the BelAir100SN should be done only by qualified service
personnel and must follow local and national safety codes. Depending on the
specific location where the BelAir100SN is installed, additional safety
regulations and practices may apply.
Liability
The recommendations made in this document are for reference only. The
customer is responsible for ensuring that installations are carried out in
compliance with national, regional and local building codes, and any applicable
electrical safety authority standards.
Always maintain safe working practices and use appropriate personal protective
equipment.
Warning — Select Appropriate Mounting for Device Weight
The BelAir100SN weighs 29 lbs (13.2 kg). It is the
responsibility of the customer/installer to ensure that the
proposed mounting location can support the weight of the
unit, including all dynamic and static adjustments as required by
the appropriate local, regional or national building safety
codes.
Caution
BelAir Networks recommends that you do not remove the
BelAir100SN from its packaging before you arrive at the
intended point of installation. This ensures that no inadvertent
damage occurs to the unit during handling.
The following installation steps assume that the proper infrastructure has
already been installed.
1 Unpack the BelAir100SN unit. Carefully remove the unit from the box.
Remove the unit from its shipping bag.
2 Refer to Figure 15. Locate the protective cover for the Ethernet connector.
If you are connecting this unit to an electrical Ethernet cable, remove the
Confidential
Document Number BDTK11001-A01 Preliminary
Page 36 of 75