Belair 100SN Installation Manual page 15

BelAir100SN Installation Guide
May 18, 2010
Warning — Use BelAir Antennas Only
Only antennas approved by BelAir Networks may be used in
conjunction with BelAir products. Contact BelAir Networks
for an up-to-date list of available approved antennas. Use of
any other antenna may exceed regulatory requirements and
void the operator's right to operate the radio equipment. Any
product damage caused by the use of non-BelAir approved
antennas will not be covered under BelAir's product warranty.
Warning — Restricted Antenna Access
Installers must ensure the BelAir product is mounted in such a
manner and in such a location that access to the antennas by
the general population is minimized. During normal operation,
access to the antennas by the general population should be
limited to 8.1 inches (20.6 cm) for units with the following
radios and antennas:
• DRU radios with BelAir antennas up to 15 dBi
During normal operation, access to the antennas by the
general population should be limited to 16.5 inches (42 cm) for
units with the following radios and antennas:
• DRU radios with BelAir antennas up to 18 dBi
Warning — Minimum Distance to Local AC Power
When installing a strand mounted unit, installers must ensure
the BelAir product and external antennas maintain at all times
at least the minimum safety distance away from any electrical
power distribution cables on the pole according to local
electrical code.
BelAir100SN Omni-directional Antenna Placement Options
Omni-directional antennas can be mounted in any of the four top corners on
the BelAir100SN unit.
Confidential
Document Number BDTK11001-A01 Preliminary
Infrastructure Requirements for the BelAir100SN
Page 15 of 75