Table of Contents
Advertisement
BelAir100SN Installation Guide
Step 5—Connect
Ethernet
Step 6—Aim Antennas
Step 7—Connect Power
May 18, 2010
Strand mounting the BelAir100SN with Directional Antennas
5 Remove the safety tether from the unit.
The unit is now securely fastened and the tether is no longer required.
Refer to
Figure 15 on page
"Step 6—Aim Antennas" on page
Electrical Ethernet Connection
Warning — Do Not Connect Ethernet Port to PoE Switch
Do not connect the BelAir unit's electrical Ethernet port
directly to a PoE output switch unless the -48 VDC PoE
outputs are disabled. The BelAir unit's electrical Ethernet port
can be damaged by -48 VDC power.
1 Locate an Ethernet gland (ordered separately from BelAir Networks).
2 Feed the gland over the Ethernet cable near the mounting bracket. (The
Ethernet cable should already be installed.)
3 Plug the Ethernet cable into the Ethernet port at the bottom of the unit.
4 Secure the first large half of the Ethernet gland. Finger tighten first, then
apply 1/8 of a turn with a large adjustable wrench or pipe wrench.
5 Secure the second half of the Ethernet gland to the first, tightening as
before. (This action compresses the gray seal onto the Ethernet cable,
forming a water proof seal.)
1 Aim the 2.4 and 5 GHz antennas at the area to be covered and tighten the
azimuth and pivot screws.
2 Use cable ties as required for cable dressing. There are dressing brackets on
the back of the antennas.
1 Ensure the plant power supply is turned off for your location and that cable
is unpowered.
2 Ensure that the unit is properly grounded. See
location of ground points of the unit.
3 Using industry standard procedures and the manufacturer' procedures,
prepare the power cable and install the coaxial cable terminator with a KS
male interface or the KS to F-type adapter. The center conductor of the KS
Confidential
Document Number BDTK11001-A01 Preliminary
37. If an Ethernet connection is not needed, go to
40.
Figure 2 on page 7
for the
Page 40 of 75
Advertisement
Chapters
Table of Contents
Troubleshooting
