General Safety Guidelines - Belair 100SN Installation Manual

BelAir100SN Installation Guide
General Safety
Guidelines
May 18, 2010
Warning
This symbol means danger. Failure to comply with this warning
could result in serious damage to life, limb or property. Before
undertaking this work, be sure to familiarize yourself with
appropriate safety practices, personal protective equipment
(PPE) and have a plan in case of accident.
While installing the BelAir100SN, follow the following general safety guidelines:
• Avoid excessive moving, touching or repositioning the unit while it is either
transmitting or receiving.
• Perform all installation steps, except fine pointing (if required) with the unit
disconnected from its power source.
• Do not attempt to install, move or reposition the unit during periods of
atmospheric electrical activity (lightning storms) or high winds.
• If you need to disconnect power from the BelAir unit, make sure to first
disconnect AC power at the source before removing the power connector
from the BelAir unit.
• When installing the unit where the ambient temperature is below 32 °F
(0 ºC), exposed metal parts will be cold. Avoid handling exposed metal
fittings with bare hands.
• Follow all local and national safety codes when installing the BelAir100SN. In
certain "hazardous" locations, installation of this equipment may be further
governed by the local site safety authority.
Warning — Installation by Qualified Personnel Only
Only personnel qualified by BelAir Networks or by one of its
authorized resellers or channel partners should install the
BelAir unit.
Warning — Read Entire Document
This entire document, including the regulatory statements
section, should be read before attempting to install or operate
the BelAir unit.
Confidential
Document Number BDTK11001-A01 Preliminary
Before You Install the BelAir100SN
Page 24 of 75