Step 4-Position And Secure Unit; Strand Mounting The Belair100Sn With Omni-Directional Antennas - Belair 100SN Installation Manual

BelAir100SN Installation Guide
Step 4—Position and
Secure Unit
May 18, 2010

Strand mounting the BelAir100SN with Omni-directional Antennas

Use thread-locker to secure the connection and ensure a waterproof seal
between the antenna and its RF cable.
As a further measure to ensure a waterproof seal and to reduce any possible
mechanical loosening of the connector, installers should wrap the connectors
with self-amalgamating tape. Installers should take steps to ensure that the
antenna connections remain mechanically tight and waterproof at all times.
1 Connect the first antenna cable to the closest antenna connector labeled
ANT-1. See Figure 10 on page
2 Connect the second antenna cable to the closest antenna connector labeled
ANT-2. See Figure 10 on page
3 Use cable ties as required for cable dressing.
1 Attach a safety tether to the BelAir100SN by passing the cable through the
space between the strand mount bracket and the unit.
Warning — Use Safety Tether
BelAir Networks recommends that a safety tether be used at
all times before the unit is securely fastened to its mounting.
Your local safety authority may require other safety measures.
Be sure to follow all local laws pertaining to workplace safety.
2 Lift the unit to the height of the strand that will be used to secure the unit.
Warning — Beware of High Voltage Lines
Caution must be observed and appropriate safety measures
taken when working around high voltage lines. Be sure to
"Check Overhead" before ascending pole or wall. Depending
on your location, you may need the services of a Certified
Contractor to obtain access to utility poles. Always follow the
applicable Workplace Safety regulations for your region. When
applicable, consult with the local utility company as well.
3 Slip the strand cable clamps over the support strand. You may need to
loosen the clamps so both halves of each clamp slides over the support
strand.
Confidential
Document Number BDTK11001-A01 Preliminary
30.
30.
Page 33 of 75