Autotest Settings; How To: Configure Autotest Settings; Test Targets - Netscout aircheck G2 User Manual

AutoTest Settings

The AutoTest Settings screen allows you to configure the
following settings:
Channel Scan Cycles — Allows you to specify the number of
times that the channels are scanned during an AutoTest. The
default value is 1, but you can set it to any value between 1
and 10, using the left or right arrow buttons.
Network Tests — Allows you to include or exclude
configured network tests as part of AutoTest, by selecting the
corresponding boxes for the networks you want to test.
NOTE: In order to see a list of networks on the AutoTest
Settings screen, you must have the networks configured
already. You can add networks and APs in the Settings menu
or by selecting Connect from a Network or AP Details
screen.
See "Entering Network Security Credentials," page 41.

How to: Configure AutoTest settings

1 Set the Channel Scan Cycles.
2 Decide to include or exclude Network Tests. If you
decide to include Network Tests, then select the boxes
for the individual networks to be tested.
3 Touch Apply to save your changes.

Test Targets

Test targets are part of Connect to Network, Connect to AP,
and AutoTest Network Tests. The Test Targets screen
provides tools for you to select, add, change, and delete test
targets.
Figure 55. Test Targets Screen
See also, "Defining Ping and TCP Port Open Test Targets" on
page 48.
81
All AirCheck G2 Settings