Autotest Network Tests; How To: Run Network Quality Tests As Part Of Autotest - Netscout aircheck G2 User Manual

AutoTest Network Tests

The Network Test measurements check for network
availability; the existence of interference from access points
using the same channel, which may cause network slowness;
AP use of consistent security methods for a network; and the
ability to connect and use the network (access to services,
other devices).

How to: Run Network Quality Tests as part of AutoTest

1 To see these tests, you must enter and save the security
credentials for the network or AP you wish to test. 
See "Entering Network Security Credentials," page 41.
2 You must also select the networks you want tested
during AutoTest from the AutoTest Settings screen
( Settings > AutoTest Settings).
Figure 18. AutoTest Settings Screen
3 Touch AutoTest from the Home Screen.
Using AutoTest to Diagnose Your Network Health
Once the SSID and security credentials have been entered,
AutoTest runs Network Tests for each network selected.
In the example shown in
"Cisco4400," has been configured and added to the Profile,
and the network is selected in AutoTest Settings.
Network Test results are reported on the AutoTest results
screen below the Air Quality test results. In
Network test for "Cisco4400" has run and passed.
Figure 19. AutoTest Results Screen
32
Figure 18, security for the SSID,
Figure 19, the