Netscout aircheck G2 User Manual page 27

Figure 7. Access Points List
The Access Points list screen displays all the access points
that AirCheck G2 has discovered.
Access Points (#): The number of APs discovered by the

Tester.
Sort (Option Field): This field shows the sort option that

is currently applied. In
Signal Strength. This is the default.
Touch the Sort field to change the order in which access
points are listed. The value by which the list is sorted
shows prominently for each access point. For example, if
you change to Sort by Client Count, the Access Points
list screen displays the number of connected clients for
each AP, instead of the Channel, as shown in
Sort Order Button: These arrows switch the list

order from ascending to descending, and vice versa.
BSSID: Basic Service Set Identifier; The MAC address of

the access point.
Signal Strength: The AP's signal strength in dBm.

Security status of the AP:

Red open lock: The network does not have security
enabled.
Yellow closed lock: One or more access points use
WEP or Cisco LEAP security protocol. These are less
secure than other protocols.
15
Discovering Networks and Access Points
Figure 7, the sort option applied is
Figure 7.