The Access Points List Screen - Netscout aircheck G2 User Manual

 For 40-, 80-, and 160-MHz channels, it displays the
primary channel number. 
 For multiple channels, it displays all channel numbers
if space permits; otherwise, it truncates to what fits,
followed by "...".
Last Seen: The time since the last packet was detected from
the selected network.
Connect: Touch this button to connect to the Wi-Fi network
and run a Connection test.
Save: Touch this button to save a session file containing
all discovered networks, APs, channels, and clients. The
session file will also include all test results for any saved
AutoTests, connection tests, Ethernet tests, and roaming and
range tests. See "Saving Sessions," page 69.

The Access Points List Screen

Touch Access Points on the Home Screen to open the list of
discovered APs.
NOTE: If Group Virtual APs is enabled in the Tester's
Settings, virtual APs are grouped by BSSID, and the
Access Points list shows individual physical APs.
If the AP grouping setting is Off, each virtual access point
is shown as a single access point.
The Tester displays an access point that supports both
bands as two separate access points, regardless of AP
grouping settings.
See "802.11 Settings," page 76.
14
Discovering Networks and Access Points