Configuring A Scheduled Software Image Reload - Cisco Catalyst 9500 Manual

Performing Device Setup Configuration
SUMMARY STEPS
1. switch:BOOT=<source path of .bin file>
2. boot
3. show version
DETAILED STEPS
Command or Action
Step 1 switch:BOOT=<source path of .bin file>
Example:
switch:
switch:BOOT=tftp://10.0.0.2/cat9k_iosxe.16.05.01a.SPA.bin
switch:
switch:
Step 2 boot
Example:
switch:boot
Step 3
show version

Configuring a Scheduled Software Image Reload

This task describes how to configure your device to reload the software image at a later time.
SUMMARY STEPS
1. enable
2. configure terminal
3. copy running-config startup-config
4. reload in [hh:]mm [text]
5. reload at hh: mm [month day | day month] [text]
6. reload cancel
7. show reload
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Device> enable
Step 2 configure terminal
Example:
System Management Configuration Guide, Cisco IOS XE Fuji 16.8.x (Catalyst 9500 Switches)
Configuring a Scheduled Software Image Reload
Purpose
Sets the boot parameters.
Boots the device.
(Optional) Displays the version of the image installed.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
73