Table of Contents
Advertisement
efesotomasyon.com - Allen Bradley,Rockwell,plc,servo,drive
ASCII Instruction Error
Codes
Error Code
Description
decimal
hexadecimal
0
0x00
No error. The instruction completed successfully.
3
0x03
The transmission cannot be completed because the
CTS signal was lost.
5
0x05
While attempting to perform an ASCII transmission, a
conflict with the configured communications protocol
was detected.
7
0x07
The instruction cannot be executed because the
communications channel has been shut down via the
channel configuration menu.
8
0x08
The instruction cannot be executed because another
ASCII transmission is already in progress.
9
0x09
Type of ASCII communications operation requested is
not supported by the current channel configuration.
Examples
For the following examples:
N7:0 = 25
N7:1 = -37
L9:0 = 508000
L9:1 = 5
Valid in-line direction:
Input:
Flow rate is currently [N7:0] liters per minute and contains [L8:0] particles per liter
contaminants.
Output:
Flow rate is currently 25 liters per minute and contains 508000 particles per liter
contaminants.
Input:
Current position is [N7:1] at a speed of [L9:1] RPM.
Output:
Current position is -37 at a speed of 5 RPM.
Invalid in-line indirection:
Input:
Current position is [N5:1] at a speed of [L9:1] RPM.
Output:
Current position is [N5:1] at a speed of 5 RPM.
.
Truncation occurs in the output string if the indirection
TIP
causes the output to exceed 82 characters. The
appended characters are always applied to the output.
The following error codes indicate why the Error bit (ER) is set in the
control data file.
ASCII Instructions
Recommended Action
None Required.
Check the modem and modem connections.
Reconfigure the channel and retry operation.
Reconfigure the channel and retry operation.
Resend the transmission.
Reconfigure the channel and retry operation.
Publication 1763-RM001C-EN-P - October 2009
337
Hide quick links:
Advertisement
Table of Contents
