Table of Contents
Advertisement
efesotomasyon.com - Allen Bradley,Rockwell,plc,servo,drive
2. Connect your process control equipment to your analog modules.
Download your program to the processor. Leave the processor in
the program mode.
ATTENTION
TIP
3. Enter the following values: the initial setpoint SP value, a reset T
0, a rate T
Set the PID mode to STI or Timed, per your ladder diagram. If STI is
selected, ensure that the loop update time equals the STI time
interval.
Enter the optional settings that apply (output limiting, output alarm,
MaxS - MinS scaling, feed forward).
4. Get prepared to chart the CV, PV, analog input, or analog output as
it varies with time with respect to the setpoint SP value.
5. Place the PID instruction in the MANUAL mode, then place the
processor in the RUN mode.
6. While monitoring the PID display, adjust the process manually by
writing to the CO percent value.
7. When you feel that you have the process under control manually,
place the PID instruction in the AUTO mode.
8. Adjust the gain while observing the relationship of the output to the
setpoint over time.
9. When you notice that the process is oscillating above and below the
setpoint in an even manner, record the time of 1 cycle. That is,
obtain the natural period of the process.
Natural Period ≅ 4x deadtime
Record the gain value. Return to the MANUAL mode (stop the
process if necessary).
Ensure that all possibilities of machine motion have been
considered with respect to personal safety and
equipment damage. It is possible that your output CV
may swing between 0 and 100% while tuning.
If you want to verify the scaling of your continuous
system and/or determine the initial loop update time of
your system, go to the procedure on page 306.
of 0, a gain K
of 1, and a loop update of 5.
d
c
Process Control Instruction
Publication 1763-RM001C-EN-P - October 2009
305
of
i
Hide quick links:
Advertisement
Table of Contents
