Usb Driver Installation; Search And Configure The Adam-2000 Series - Advantech ADAM-2000 Series User Manual

5.3.1

USB Driver Installation

If the user wants to use USB cable to connection with AdamApax .NET Utility on PC,
they need to install USB chip driver in CD.
Step 1
Connect a USB cable between the ADAM-2520Z and the PC, and the system will
pop out message to install new device, find the USB folder to select USB chip driver
in out CD.
Base on your PC for 32 bit or 64 bit to select your suitable USB chip driver, then PC
will auto install. After install finished, you can see which port your system get in
device manager like bellow one. (Note: base on your system, this picture just for
sample)
Then restart the AdamApax .NET Utility.
5.3.2

Search and Configure the ADAM-2000 Series

The ADAM-2000 series can be searched and configured through AdamApax .NET
Utility. Make sure the ADAM-2000 devices are installed properly in Initial Mode. For
more information, please refer to the Chapter 4.2.
The supported Wireless Sensor Networks Modules are listed in the information page
.
Figure 5.3 ADAM-2000 Series AdamApax .NET Utility Support
51 ADAM-2000 Series User Manual