Table of Contents
Advertisement
Chapter 5 SVGA Setup
5.1 Introduction
The PCM-3348 has an on-board VGA interface. The specifications and
features are described as follows:
5.1.1 Chipset
The PCM-3348 uses a SGS Thomson STPC for its SVGA controller,
which supports conventional analog CRT monitors. In addition, it also
supports interlaced and non-interlaced analog monitors (color and mono-
chrome VGA) in high-resolution modes while maintaining complete IBM
VGA compatibility. Digital monitors (i.e. MDA, CGA, and EGA) are
NOT supported. Multiple frequency (multisync) monitors are handled as
if they were analog monitors.
5.1.2 Display memory
PCM-3347 has on board 2 MB (CT69000) and PCM03348 with 512 K ~
4 MB shared memory, the VGA controller can drive CRT displays or
color panel displays with resolutions up to 1024 x 768 at 64 K colors.
5.2 Installation of SVGA driver
Complete the following steps to install the SVGA driver. Follow those
procedures in the flow chart that apply to the operating system which you
are using within your PCM-3348.
Important:The following windows illustrations are examples only. You
must follow the flow chart instructions and pay attention to the instruc-
tions which then appear on your screen.
Note 1:
Note 2:
PCM-3347 User's Manual
The CD-ROM drive is designated as "D" through-
out this chapter.
<Enter> means pressing the "Enter" key on the
keyboard.
36
Advertisement
Table of Contents
