Advantech ADAM-2000 Series User Manual page 53

4.2.2.4 End Device Configuration Flowchart
The section tells the user how to setup the End Devices to do data acquisition of a
PAN for a wireless sensor network.
Please refer to
Appendix B for
troubleshooting.
Initial Mode:
Status LED turns on,
Join PAN with
Pair ID 1
Press Function Button 3
times to join the PAN.
Amber LED turns on.
Error LED blinks.
No
Error LED turns off
Successfully join a PAN
with default PAN ID and
RF channel. Amber
LED indicating Pair ID.
Open AdamApax .NET
Utility to configure the
ADAM-2000 series,
refer to Chapter 5 for
more information.
Install Power
All LEDs turn On
(Green LED turns on while powering by
external/USB power)
No
Configured ready for
Normal Mode
Press Function Button 5
No
times to change Pair ID.
Yes
Yes
Yes
43 ADAM-2000 Series User Manual
Please refer to
Appendix B for
troubleshooting.
Normal Mode:
Status LED turns off,
Error LED blinks.
No
Error LED turns off
Yes
Successfully join a PAN
with user defined PAN
ID and RF channel.
Transmit data/signal to
Coordinator.