Basic Settings For Single Axis - ICP DAS USA i8094A Getting Started

3.7.2 Basic Settings For Single Axis

1. Setting the mode of Acceleration/deceleration: There are four speed modes of
operation：
0 Symmetrical T-Profile (SV、V、A、AO)
1 Symmetrical S-curve (SV、V、K、AO)
2 Asymmetrical T-profile (SV、V、A、D、AO)
3 Asymmetrical S-curve (SV、V、K、L、AO)
Please refer to Manual "i8094H_Manual_1.3tc.pdf" section 6.1.1, function
i8094H_NORMAL_SPEED() for detail settings.
2. Setting the start velocity: Set lowest speed：
Please refer to Manual "i8094H_Manual_1.3tc.pdf" section 6.1.2, function
i8094H_SET_SV() for detail settings.
3. Setting the Velocity: Set the speed at a certain rate：
Please refer to Manual "i8094H_Manual_1.3tc.pdf" section 6.1.3, function
i8094H_SET_V() for detail settings.
4. Setting the Acceleration/Deceleration speed: Set the Acceleration/Deceleration
speed at a certain rate：
Please refer to Manual "i8094H_Manual_1.3tc.pdf" section 6.1.4, function i
i8094H_SET_A() for detail settings.
Please refer to Manual "i8094H_Manual_1.3tc.pdf" section 6.1.5, function
i8094H_SET_D() for detail settings.
http://www.icpdas.com
I8094A &I8094HGetting Started manual
Ver 1.3-- 44