Signal Connections For Dn-8468P - ICP DAS USA i8094A Getting Started

B.2.2 Signal Connections for DN-8468P
Maintaining signal connections is one of the most important factors in ensuring that your
application system is sending and receiving data correctly.
Pin Assignment for CON1
The I/O connector on the DN-8468P is a 68-pin SCSI II connector that enables you to connect to
the PISO-PS400 motion card. Please refer to the section 2.2.1( page 15).
TB1
The connector TB1 is 7-pin connector that enables you to connect to the signals of your motor
drivers. Fig.1-3 shows the pin assignment for the 7-pin connector on the DN-8468P, and the
Table 1-4 shows its I/O connector signal description.
TB2
The connector TB2 is 5-pin connector that enables you to connect to the signals of your motor
drivers. Fig.1-4 shows the pin assignment for the 5-pin connector on the DN-8468P, and the
Table 1-5 shows its I/O connector signal description.
http://www.icpdas.com
I8094A &I8094HGetting Started manual
Ver 1.3-- 79