Table of Contents
Advertisement
3. Fit the front middle left log (whale
tail in the front) into the back flat
section of the burner, and swing
over so that it slots on top of the
front base left log.
4. Place the y-shaped log securely
in the back recess of the burner
(there is a cutout in the log and
in the back of the burner)—it will
almost touch the back burner
cover.
5. Place the top bent log over the
u-shaped log and the whale
tail log—there are pockets
underneath to help position it
properly. For correct positioning
ensure that the top bent log is
located on the three points shown.
6. Place the round flat rock and front
left rock over the burner screw
holes. Keep them as far away as
possible from the glass, while
making sure they still cover the
holes.
Place the remaining triangular
shaped rock on top of the round
flat rock as shown.
After all pieces are in position double check everything is sitting flat with little or no
movement—they should be stable and not wobble.
3
5
6
4
6
RDV3611 installation guide: 11156-E 05-16 | 15
Advertisement
Table of Contents
