Table of Contents
Advertisement
Flame pattern
It may take approximately two hours of operation for the logs to achieve their full
flame pattern and glow. During this burning in period some smoke and smell may be
experienced. The appliance should run on the high setting in a well ventilated room
until these dissipate. It is important to check the flame pattern during this time.
Abnormal flame pattern
Abnormal flame performance and/or flame pattern can indicate a problem with the fire such as
blocked gas injectors or log set that may have shifted. There are some warning signs that could
indicate a problem.
- Unusual smell from the appliance
- Continued difficulty or delay in establishing a flame
- Flame appears either very short or very long
- Flame only burns part way across the burner
- Severe soot building up on the inside of the glass door
Important
It is the responsibility of the installer to check that under normal conditions of the appliance, all
flue gases are exhausted to the outside atmosphere and that there is no spillage of combustion
gases into the room.
If the appliance cannot be made to perform correctly please contact Rinnai.
Normal flame pattern
Abnormal flame pattern
RDV3611 installation guide: 11156-E 05-16 | 17
Advertisement
Table of Contents
