Table of Contents
Advertisement
Fitting the frames and dress guard
Before fitting the frames and dress guard (optional accessory), ensure the
glass front is secured in place. It is critical when fitting the glass front that you
WARNING
double check that it is not scratched or damaged in any way, and that you
have checked the gasket.
Outer frame: Standard outer frame
Screw into position with the four screws provided. If you have the granite outer frame—refer
separate installation instructions provided with the frame.
Outer frame: Premium flat frame
Disconnect the CAT5 cable from the RJ45 connector inside the white PCB box and connect the
CAT5 cable on the manual switch, at the top right of the outer frame, directly to the PCB. Fit the
outer frame by using the two retaining screws located on the inner left hand side, and the two
screws on the inner right hand side of the burner box. Cover the lower manual control switch
with the blanking sticker supplied with the frame.
Inner frame
Hook over the glass panel assembly and secure in place on the two large lower magnets on the
front assembly.
Standard frame
Premium flat
frame
Please note: The CAT5 cable on the manual switch, at the top right of the outer frame, connects directly into the white PCB box.
Commissioning
Complete the installation and commissioning checklist in the customer operation
guide and leave this with the homeowner. Explain to them about the use and care of
the fire, and that they understand the instructions and operation of the appliance.
If operating without a dress guard, advise the customer of the safety instructions to
prevent the risk of injury.
Glass assembly
Cover the lower manual control switch
blanking sticker supplied.
RDV3611 installation guide: 11156-E 05-16 | 19
Advertisement
Table of Contents
