Table of Contents
Advertisement
Log set installation
The log set is packaged separately and consists of five log pieces and three
moulded rocks. Use extreme care when handling the log pieces, they are made
from fragile material and will damage easily.
Use these instructions in conjunction with the log location guide, which
is attached to the engine. Experience has shown that the majority of
IMPORTANT
performance problems have been caused by the log set being installed
incorrectly.
6
It is important to place the pieces in the correct position. Incorrect placement can create
carbon build-up and affect performance. Malfunctioning due to incorrect log/rock placement is
not covered by warranty. The unit MUST NEVER be used with broken logs or rocks or other burn
media.
1. Carefully remove the log set
from the packaging and fit
the front base left log (with
moulded rock). There is a cutout
in the back of the log and in
the burner—it should only fit
one way, sitting flat with no
movement.
2. Fit the snake shaped log into
the curve on the far right of the
burner base. It should sit hard
up against the burner and once
positioned not rock or wobble.
14 | RDV3611 installation guide: 11156-E 05-16
5
3
1
4
2
1
6
2
Advertisement
Table of Contents
