Sending An Image In Usb Memory Mode - Sharp MX-M950 Software Manual

SENDING AN IMAGE IN USB MEMORY MODE

Follow the steps below to send a scanned image to a commercially available USB memory device that has been
connected to the machine. This stores the file in the USB device.
• Consult your dealer or retailer for USB memory devices that can be used.
• When a default address is configured in "Default Address Setting" in the system settings (administrator), the mode cannot
be changed. To switch to USB memory mode, touch the [Cancel] key in the touch panel and then follow the steps below.
1
• When placing the originals, orient them as shown below.
Originals
Portrait orientation*
A
2
B
Landscape orientation
A B
* To place a large portrait-oriented original, place it as shown above in "Landscape orientation" and specify the
placement orientation in step 4.
• Place 5-1/2" x 8-1/2" (A5) size originals in portrait (vertical) orientation (
orientation (
manually.
• Originals cannot be scanned in succession from both the automatic document feeder and the document glass and
sent in a single transmission.
Document feeder tray
Place the original face up.
), an incorrect size will be detected. For a 5-1/2" x 8-1/2"R (A5R) size original, enter the original size
Connect the USB memory to the USB
connector (Type A) on the machine.
Place the original.
Place the original face down and align the corner
with the tip of the arrow mark
corner of the document glass scale.
A
B
A B
43
Document glass
in the top left
A
B
B A
). If placed in landscape (horizontal)