Sharp MX-M950 Software Manual page 117

Internet Fax/Original
Scan Size
Auto
6
2-Sided 2-Sided
Booklet Tablet
Press the [START] key (
Scanning begins.
• If you inserted the original pages in the document feeder tray, all pages are scanned.
A beep will sound to indicate that scanning is finished.
• If you are scanning the original on the document glass, scan each page one page at a time.
When scanning finishes, place the next original and press the [START] key (
scanned and then touch the [Read-End] key.
7
A beep will sound to indicate that scanning is finished.
The [Configure] key can be touched in the scan-end confirmation screen to change the exposure, resolution, scan
size, and send size. (However, when scanning each even-numbered page of the original, only the exposure can be
changed.)
To cancel scanning...
Press the [STOP] key (
• Transmission is not possible at a size smaller than the original size.
• The 2in1 function cannot be used when the original is other than 8-1/2" x 11" or 5-1/2" x 8-1/2" (A4, B5, or A5) size.
• When the scan size of the original is specified by numerical values, this function cannot be used.
• Fax mode:
This function cannot be used in direct transmission mode or when the speaker is used to dial.
To cancel 2in1...
Touch the [2in1] key in the screen of step 4 so that it is not highlighted.
100% Send Size
Auto
8½x11
Image Orientation
(1)
).
) to cancel the operation.
Specify the orientation in which the
(2)
original is placed.
OK
(1) Touch the "Image Orientation" key with the
same orientation as the original image.
If this setting is not correct, a suitable image may not be
transmitted.
(2) Touch the [OK] key.
117
). Repeat until all pages have been