Sharp MX-M950 Software Manual page 84

Internet fax mode
The file format for sending an Internet fax is normally set to [TIFF-F]. If the destination Internet fax machine does not
support full mode (it only supports simple mode), follow the steps below to select [TIFF-S].
Switch to Internet fax mode and display the file format settings screen.
(1) Touch the [Internet Fax] tab.
1
(2) Touch the [File Format] key.
☞
IMAGE SETTINGS
Internet Fax/File Format
2
TIFF-S
When [TIFF-S] is selected, the transmission settings are restricted as follows:
• Resolution: The selections are [200X100dpi] and [200X200dpi]. If [TIFF-S] is selected after [200X400dpi], [400X400dpi] or
[600X600dpi] is selected, the resolution automatically changes to [200X200dpi].
• Send size: Always 8-1/2" x 11"R (A4R). If [TIFF-S] is selected after the send size is changed, the send size is
automatically changed to 8-1/2" x 11"R (A4R). If a size larger than 8-1/2" x 11" (A4) is scanned, the size will
automatically be reduced to 8-1/2" x 11"R (A4R). When this format is included in a broadcast transmission, the
image will be transmitted to all destinations at 8-1/2" x 11"R (A4R).
• Special modes: When a ratio setting is selected and the original size is entered, Dual Page Scan, Card Shot, 2in1, and
System Settings (Administrator): Compression Setting
This is used to set the default compression mode for Internet fax transmission.
(page 68)
(1)
File Type Compression Mode
TIFF-F MH (G3)
MMR (G4)
Mixed Size Original cannot be used.
Select the file format.
(2)
(1) Touch the key of the desired format.
OK
If you selected [TIFF-F], select the compression mode.
(2) Touch the [OK] key.
84