Yamaha XVS6501997 Service Manual page 260

SHAFT DRIVE
3. Remove:
S Final drive roller bearing 1
*****************************************************
Removal steps:
D Heat the final gear case to 150_C.
D Using an appropriately shaped punch 2 re-
move the roller bearing outer races.
D Remove the inner race from the final drive
shaft.
NOTE:
The removal of the final drive shaft roller bear-
ing is a difficult procedure and is rarely neces-
sary.
*****************************************************
4. Install:
S Final drive roller bearing (new)
*****************************************************
Installation steps:
D Heat the final gear case to 150_C.
D Install the roller bearing outer races using the
proper adapter.
D Install the inner race onto the drive shaft.
*****************************************************
5. Install:
S Guide collar 1
S Oil seal 2
S Roller bearing (outer race) 3
To install the above components into the
final gear case use a suitable press tool 4
and a press.
6-60
CHAS